Loading...
Alt

Due to illness, orders cannot be delivered at the moment. We assume that we will be able to ship normally again from 23.10.2024. Unfortunately, collection is also not possible during this time.

 

Trampa Internal Bearing support spacer used with 10mm O-RIng on 12mm axles


1,50 €
*
 (0 reviews)

This special Spacer measures 12mm (id) x 16mm (od) x 16.5mm (long) & is known as a Bearing Support Spacer. This Bearing Support Spacer fits between the Bearings, along side the 10mm O-Ring when fitting Bearings into a TRAMPA hub when mounting the wheel onto 12mm Axles.



Over time, during the usage of your board, the bearings & spacers are put under a lot of force. Ultimately this force has to go somewhere... The Bearings use a Steel ring in their assembly where as the Bearing Support Spacers are made from Aluminum. Steel is much stronger than Aluminum & when forced against each the aluminum will loose out every time! This is what happens to your spacers between the bearings, the Bearings put force onto your spacers as a consequence over time the spacers shrink... With enough time its possible for an annoying rattle to start.... That's when you fit these 16.5mm spacers with the little 10mm O-Rings to prevent the rattles!! :-)

Brands

AltAltAltAltAltAltAltAltAltAltAltAltAltAlt